LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1676 (Engine Mechanical - 3.8L) >> Repair Instructions >> Off-Vehicle Repair Instructions >> Drive Belt Idler Pulley Bracket Installation (L67)

Drive Belt Idler Pulley Bracket Installation (L67)

WARNING: This page is about a different car, the 2003 Buick Regal. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the drive belt idler pulley bracket.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the drive belt idler pulley bracket bolts.

    Tighten 

    Tighten the drive belt idler pulley bracket bolts to 30 N.m (22 lb ft).

    Fig 1: Installing Drive Belt Idler Pulley, Bolt & Bracket (L67)
    G01969528Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals