LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1675 (Engine Mechanical - 3.1L V6 - VIN (J)) >> Repair Instructions >> On-Vehicle repair Instructions >> Engine Mount Strut Bracket Replacement - Right >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the right engine mount strut bracket over the pin locator.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the bolts through the right engine mount strut bracket to the cylinder head.

    Tighten 

    Tighten the engine mount strut bracket bolt to 50 N.m (37 lb ft).

  3. Install the air conditioner compressor. Refer to COMPRESSOR REPLACEMENT (3.1L) in Heating, Ventilation, and Air Conditioning.

    Tighten 

    Tighten the air conditioning compressor mounting bolts to 50 N.m (37 lb ft).

    Fig 1: Installing Air Conditioning Compressor & Mounting Bolts
    G01967834Courtesy of GENERAL MOTORS CORP.
  4. Install the right engine mount strut to the right engine mount strut bracket. Refer to ENGINE MOUNT STRUT REPLACEMENT  .
    Fig 2: Installing Right Engine Mount Strut To Right Engine Mount Strut Bracket
    G01967835Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals