LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1675 (Engine Mechanical - 3.1L V6 - VIN (J)) >> Repair Instructions >> Off-Vehicle Repair Instructions >> Water Pump Installation

Water Pump Installation

WARNING: This page is about a different car, the 2003 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the water pump gasket.
  2. Install the water pump.
    Fig 1: Installing Water Pump, Gasket & Mounting Bolts
    G01968207Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  3. Install the water pump bolts.

    Tighten 

    Tighten the water pump bolts to 10 N.m (89 lb in).

  4. Install the water pump pulley.
    Fig 2: Installing Water Pump Pulley & Mounting Bolts
    G01968208Courtesy of GENERAL MOTORS CORP.
  5. Install the water pump pulley bolts.

    Tighten 

    Tighten the water pump pulley bolts to 25 N.m (18 lb ft).

scientia non olet · About LEMON Manuals