LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1675 (Engine Mechanical - 3.1L V6 - VIN (J)) >> Repair Instructions >> Off-Vehicle Repair Instructions >> Oil Pump Drive Installation

Oil Pump Drive Installation

WARNING: This page is about a different car, the 2003 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
  1. Apply prelube GM P/N United States 12345501, (GM P/N Canada 992704) or the equivalent to the oil pump drive gear.
  2. Apply engine oil to the oil pump drive gear assembly for ease of assembly.
  3. Install the oil pump drive gear assembly.
    Fig 1: Installing Oil Pump Drive Gear Assembly, Clamp & Mounting Bolt
    G01968196Courtesy of GENERAL MOTORS CORP.
  4. Install the oil pump drive gear clamp.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  5. Install the oil pump drive gear clamp bolt.

    Tighten 

    Tighten the oil pump drive gear clamp bolt to 36 N.m (27 lb ft).

scientia non olet · About LEMON Manuals