LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1669 (Steering Wheel And Steering Column) >> Repair Instructions >> Shift Lever Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Buick Regal and 2003 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the shift lever seal (2) onto the shift lever assembly (4).
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the shift lever assembly (4) and secure it with the shift lever screw (3).

    Tighten 

    Tighten the screw to 20 N.m (15 lb ft).

    IMPORTANT: The shift lever boot must be seated inside the trim covers.
  3. Slide the shift lever boot into the trim covers.
  4. Install the steering column trim covers. Refer to STEERING COLUMN TRIM COVERS REPLACEMENT  .
    Fig 1: Installing Steering Column Trim Covers
    G01569275Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals