LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1664 (Horn System) >> Repair Instructions >> Horn Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise the hood.
  2. Remove the headlamp assembly. Refer to HEADLAMP ASSEMBLY OR HEADLAMP BULB REPLACEMENT (EXCEPT AVALANCHE) or HEADLAMP ASSEMBLY OR HEADLAMP BULB REPLACEMENT (AVALANCHE) or HEADLAMP ASSEMBLY OR HEADLAMP BULB REPLACEMENT (ESCALADE) .

  3. Remove the park/turn signal lamp assembly. Refer to PARK/TURN SIGNAL LAMP REPLACEMENT (EXCEPT AVALANCHE) or PARK/TURN SIGNAL LAMP REPLACEMENT (AVALANCHE) .
    4. Fig 1: Horn & Radiator Support
    GM331104Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the horn electrical connector.
  5. Remove the horn bolt. Reposition the park/turn signal lamp wiring harness for additional clearance.
  6. Remove the horn (2) from the radiator support (1). Left side and right side horn assemblies are shown.
scientia non olet · About LEMON Manuals