LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1661 (Wiper System & Washer System) >> Repair Instructions >> Wiper/Washer Switch Replacement - Rear >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the switch to the trim plate.
  2. Connect the electrical connector to the wiper washer switch.
    Fig 1: Wiper/Washer Switch
    GM651277Courtesy of GENERAL MOTORS CORP.
  3. Install the switch to the instrument panel trim plate, ensuring that the locking tabs are properly seated.
  4. Install the instrument panel (IP) accessory trim plate. Refer to TRIM PLATE REPLACEMENT - INSTRUMENT PANEL (I/P) ACCESSORY (CHEVROLET) or TRIM PLATE REPLACEMENT - INSTRUMENT PANEL (I/P) ACCESSORY (OLDSMOBILE) in Instrument Panel, Gages and Console.
scientia non olet · About LEMON Manuals