LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1661 (Wiper System & Washer System) >> Repair Instructions >> Wiper Motor Cover Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the wiper cover and module to the wiper motor.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the 3 screws retaining the wiper motor cover to the wiper motor.

    Tighten:  Tighten the 3 wiper motor cover screws to 3 N.m (27 lb in).

    Fig 1: Wiper Motor Cover Retaining Screws
    GM751559Courtesy of GENERAL MOTORS CORP.
  3. Install the wiper transmission assembly to the vehicle. Refer to Wiper Transmission Replacement .
scientia non olet · About LEMON Manuals