LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1661 (Wiper System & Washer System) >> Repair Instructions >> Wiper Arm Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Mark the position of the wiper blade on the windshield with a suitable marker or a piece of masking tape.
  2. Remove the cover from the nut on the wiper arm.
  3. Remove the nut from the wiper arm.
    IMPORTANT: Use a battery terminal puller to remove the wiper arm if rocking the wiper arm fails to loosen it from the drive shaft.
  4. Rock the wiper arm back and forth to loosen it from the drive shaft.
    Fig 1: Wiper Arm Blade & Wiper Arm
    GM751297Courtesy of GENERAL MOTORS CORP.
  5. Remove the wiper arm from the drive shaft.
  6. Remove the wiper arm blade from the wiper arm. Refer to Wiper Arm Replacement .
  7. Clean the knurls of the drive shaft with a wire brush.
scientia non olet · About LEMON Manuals