LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1661 (Wiper System & Washer System) >> Repair Instructions >> Wiper Arm Replacement - Rear >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the wiper arm blade to the wiper arm, if removed. Refer to Wiper Arm Blade Replacement - Rear .
  2. Position the wiper arm into the park ramp.
    Fig 1: View Of Rear Wiper
    GM751295Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  3. Install the wiper arm onto the motor shaft with the nut (3).

    Tighten:  Tighten the nut (3) to 20 N.m (15 lb ft).

  4. Install the wiper arm cover (2).
  5. Connect the washer hose (4).
scientia non olet · About LEMON Manuals