LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1661 (Wiper System & Washer System) >> Diagnostic Information and Procedures >> Wipers Inoperative - All Modes

Wipers Inoperative - All Modes

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
Wipers Inoperative - All Modes

Step Action Yes No
Schematic Reference: CONNECTOR REPAIRS
Connector End View Reference: Wiper/Washer System Connector End Views 
DEFINITION: Windshield wipers are inoperative in all modes.
1 Did you perform the Wiper/Washer Diagnostic System Check? Go to Step 2  Go to Diagnostic System Check - Wiper/Washer 
2
  1. Turn ON the ignition.
  2. Attempt to operate the windshield wipers in all modes.
Are the windshield wipers inoperative in all modes?
Go to Step 3  Go to TESTING FOR INTERMITTENT CONDITIONS AND POOR CONNECTIONS in Wiring Systems
3
  1. Turn OFF the ignition.
  2. Disconnect the windshield wiper motor connector.
  3. Turn ON the ignition.
  4. Connect a test lamp between the accessory voltage supply circuit terminal and the ground circuit terminal of windshield wiper motor in the windshield wiper motor harness connector.
Does the test lamp illuminate?
Go to Step 4  Go to Step 7 
4 Connect a test lamp from the accessory voltage supply circuit terminal in the windshield wiper motor harness connector to a good ground.
Does the test lamp illuminate?
Go to Step 5  Go to Step 8 
5
  1. Remove the wiper motor cover from the wiper motor.
  2. Connect a test lamp from the wiper motor ground terminal T3 to the low speed supply terminal T1 on the wiper motor cover.
  3. With the harness connector connected to the wiper motor cover operate the wiper switch to the low speed position.
Does the test lamp illuminate for approximately 15 seconds?
Go to Step 10  Go to Step 6 
6 Inspect for poor connections at the windshield wiper motor connector. Refer to TESTING FOR INTERMITTENT CONDITIONS AND POOR CONNECTIONS and CONNECTOR REPAIRS in Wiring Systems.
Did you find and correct the condition?
Go to Step 11  Go to Step 9 
7 Repair an open or short to ground in the accessory voltage supply circuit to the windshield wiper motor. Refer to CIRCUIT TESTING and WIRING REPAIRS in Wiring Systems.
Is the repair complete?
Go to Step 11  -
8 Repair an open or high resistance in the windshield wiper motor ground circuit. Refer to CIRCUIT TESTING and WIRING REPAIRS in Wiring Systems.
Is the repair complete?
Go to Step 11  -
9 Replace the windshield wiper motor cover. Refer to Wiper Motor Cover Replacement .
Is the repair complete?
Go to Step 11  -
10 Replace the windshield wiper motor.
Is the repair complete?
Go to Step 11  -
11 Operate the system in order to verify the repair.
Did you correct the condition?
System OK Go to Step 3