Action Taken When the DTC Sets
WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
- The vehicle will not start if the fault occurs before you start the vehicle. The security indicator will be FLASHING.
- If the vehicle is running when the fault occurs, the BCM will be in the fail enable mode allowing the vehicle to start and run. The security indicator will be ON.
- The DTC will set only when the engine is running.
- The BCM will be in the fail enable mode allowing the vehicle to start and run.
- The vehicle will hot run. The security indicator will be flashing.
- The Passlock state is Tamper.