Removal Procedure
WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the liftgate upper molding. Refer to MOLDING REPLACEMENT - LIFTGATE UPPER in Exterior Trim.
- Open the liftgate window (1).
- Remove the liftgate window handle bolts (3).
- Remove the outside handle (4) and striker from the liftgate window.
- Remove the liftgate window defogger electrical connectors (2) from the right and left sides.
- With the aid of an assistant remove the struts (3) from the liftgate window. Refer to STRUT REPLACEMENT - Lift Gate .
- Lower the liftgate window (1).
- With the liftgate closed, remove the hinge pin C-clips (2) and (3) from the liftgate window hinges.
- Remove the hinge pins (1).
- Remove the liftgate window from the vehicle with the aid of an assistant.
IMPORTANT:
Ensure that the liftgate is closed before starting the removal procedure on the liftgate window.
CAUTION:
Refer to GLASS & SHEET METAL HANDLING CAUTION
in Cautions and Notices.
CAUTION:
When a lift gate hold open device is being removed or installed, provide alternate support to avoid the possibility of damage to the vehicle or personal injury.
IMPORTANT:
Do not open liftgate once the hinge pins have been removed from the liftgate window.