Installation Procedure
WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
- Install the liftgate window to the vehicle with the aid of an assistant.
- With the liftgate closed align the liftgate windows hinge pin holes, install the hinge pins (1).
- Install the hinge pin C-clips (2) and (3) to the liftgate window hinge pins.
- Open the liftgate window.
With the aid of an assistant install the struts (3) to the liftgate window. Refer to STRUT REPLACEMENT - Lift Gate .
- Install the outside handle (4) and striker to the liftgate window.
- Install the liftgate window handle bolts (3).
Tighten: Tighten the liftgate window handle bolts (3) to the striker plate to 5 N.m (44 lb in).
- Install the liftgate window defogger electrical connectors (2) to the right and left sides.
- Install the liftgate upper molding. Refer to MOLDING REPLACEMENT - LIFTGATE UPPER in Exterior Trim.
- Inspect the operations of the liftgate window and center high mounted stop lamp (CHMSL).
- Close the liftgate window.
IMPORTANT:
Do not open the liftgate once the hinge pins have been removed from the liftgate window.
NOTE:
Refer to Fastener Notice FASTENER NOTICE
in Cautions and Notices.