LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1658 (Body Rear End) >> Repair Instructions >> Actuator Replacement - Rear Quarter Window >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Disconnecting Electrical Connection
    GM830984Courtesy of GENERAL MOTORS CORP.
  1. Remove the rear interior trim panel covering the actuator. Refer to GARNISH MOLDING REPLACEMENT - BODY SIDE WINDOW - REAR (TRAILBLAZER EXT, ENVOY XL) in Interior Trim.
  2. Disconnect the electrical connection (1).
    3. Fig 2: Removing Actuator Arm To Window Hinge Screw
    GM1231409Courtesy of GENERAL MOTORS CORP.
  3. Remove the actuator arm (1) to the window hinge screw (2).
  4. Remove the actuator retaining nuts.
  5. Remove the actuator from the vehicle.
    6. Fig 3: Securing Window Bracket To Window Frame
    GM1231176Courtesy of GENERAL MOTORS CORP.
  6. Using a 2.0 mm (0.08 in) pin (1), secure the window bracket (3) to the window frame (4).
scientia non olet · About LEMON Manuals