LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1657 (Lighting Systems) >> Repair Instructions >> Tail Lamp Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the 2 screws that retain the tail lamp assembly to the body.
  2. Pull the assembly directly rearward in order to release the 2 locking pins.
  3. Disconnect the tail lamp electrical connector.
  4. Remove the lamp assembly from the vehicle.
    Fig 1: Tail Lamp Assembly Removed
    GM718032Courtesy of GENERAL MOTORS CORP.
  5. Remove the tail lamp circuit board. Refer to Tail Lamp Circuit Board Replacement .
scientia non olet · About LEMON Manuals