LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1657 (Lighting Systems) >> Repair Instructions >> Tail Lamp Circuit Board Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the tail lamp. Refer to Tail Lamp Replacement .
  2. Remove the 2 tail lamp circuit board retaining screws.
  3. Simultaneously release the bottom 4 locking tabs and partially remove the tail lamp circuit board.
  4. Release the top 2 locking tabs and remove the tail lamp circuit board from the tail lamp assembly.
    Fig 1: Removing/Installing Tail Lamp Circuit Board
    GM732917Courtesy of GENERAL MOTORS CORP.
  5. Remove the bulbs from the tail lamp circuit board.
scientia non olet · About LEMON Manuals