LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1657 (Lighting Systems) >> Repair Instructions >> Instrument Panel (I/P) Compartment Lamp Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the bulb to the socket.
  2. Install the trim panel to the IP.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  3. Install the 5 screws that retain the IP compartment jamb trim panel to the IP.

    Tighten:  Tighten the screws to 1.9 N.m (17 lb in).

    Fig 1: Removing/Installing IP Compartment Jamb Trim Panel Retaining Screws
    GM740920Courtesy of GENERAL MOTORS CORP.
  4. Position the socket assembly to the trim panel and connect the electrical connector.
    Fig 2: Locating Instrument Panel (I/P) Compartment Lamp Socket & Electrical Connector
    GM692026Courtesy of GENERAL MOTORS CORP.
  5. Install the socket assembly to the trim panel. Verify that the retaining tabs are fully seated.
  6. Close the IP compartment.
scientia non olet · About LEMON Manuals