LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1657 (Lighting Systems) >> Repair Instructions >> High Mounted Stop Lamp Replacement (Envoy, Trailblazer, Rainier, Bravada) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Open the liftgate.
  2. Lower the rear portion of the headliner by releasing the 2 headliner retaining pins.
  3. Disconnect the high mount stoplamp electrical connector (2).
    Fig 1: Accessing High Mount Stoplamp Electrical Connector (Envoy, Trailblazer, Rainier, Bravada)
    GM721363Courtesy of GENERAL MOTORS CORP.
  4. Remove the grommet (1) from the body
    NOTE: Do NOT raise the liftgate while the liftgate glass is open. This can result in damage to the high-mounted stoplamp, the liftgate hinges, or the liftgate glass.
  5. Close the liftgate.
  6. Open the liftgate window.
  7. Remove the 2 screws that retain the high mount stoplamp to the lift gate window reveal molding.
    Fig 2: High Mount Stoplamp Retaining Screws
    GM732876Courtesy of GENERAL MOTORS CORP.
  8. Remove the high mount stoplamp from the vehicle.
scientia non olet · About LEMON Manuals