LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1657 (Lighting Systems) >> Repair Instructions >> High Mounted Stop Lamp Replacement (Envoy, Trailblazer, Rainier, Bravada) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the high mount stoplamp to the lift gate window reveal molding, ensuring the center retaining tab is fully seated.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the 2 screws that retain the high mount stoplamp to the lift gate window reveal molding.

    Tighten:  Tighten the 2 retaining screws to 2.5 N.m (22 lb in).

    Fig 1: High Mount Stoplamp Retaining Screws
    GM732876Courtesy of GENERAL MOTORS CORP.
  3. Close the liftgate window.
  4. Open the liftgate.
  5. Install the grommet (1) to the body.
    Fig 2: Accessing High Mount Stoplamp Electrical Connector (Envoy, Trailblazer, Rainier, Bravada)
    GM721363Courtesy of GENERAL MOTORS CORP.
  6. Connect the high mount stoplamp electrical connector (2).
  7. Attach the rear portion of the headliner to the roof panel, by seating the 2 headliner retaining pins.
  8. Position the lift gate opening weatherstrip over the headliner.
scientia non olet · About LEMON Manuals