LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1657 (Lighting Systems) >> Repair Instructions >> Hazard and Turn Signal Flasher Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the flasher to the insulator panel.
  2. Connect the electrical connector to the flasher.
    Fig 1: Flasher Retaining Bracket And Electrical Connector
    GM763321Courtesy of GENERAL MOTORS CORP.
  3. Install the flasher retaining bracket to the insulator panel.
  4. Install the left closeout/insulator panel. Refer to CLOSEOUT/INSULATOR PANEL REPLACEMENT - LEFT in Instrument Panel, Gages and Console.
scientia non olet · About LEMON Manuals