LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1657 (Lighting Systems) >> Repair Instructions >> Dome and Reading Lamp Bulb Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. If replacing the dome lamp bulb (1), install the dome lamp bulb to the socket.
    Fig 1: Dome Lamp Bulb
    GM762153Courtesy of GENERAL MOTORS CORP.
  2. If replacing the reading lamp bulb (1), install the reading lamp bulb to the socket.
    Fig 2: Reading Lamp Bulb And Reflector
    GM762152Courtesy of GENERAL MOTORS CORP.
  3. Install the reflector (2) to the dome lamp, ensuring the retaining tabs are fully seated.
  4. Position the lens to the headliner with the horizontal tab facing forward.
    Fig 3: Removing/Installing Headliner Lens
    GM729430Courtesy of GENERAL MOTORS CORP.
  5. Position the horizontal tab above the headliner and push the lens forward to seat the tab.
    Fig 4: Exposing Rear Retaining Tab
    GM729429Courtesy of GENERAL MOTORS CORP.
  6. Push upward on the rear portion of the lens, in order to seat the rear lens retaining tab.
  7. Pull down on the lens to ensure that the lens is secured to the headliner.