High Beam Indicator Inoperative

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.

Step	Action	Yes	No
1	Did you perform the Lighting Systems Diagnostic System Check?	Go to Step 2	Go to Diagnostic System Check - Lighting Systems
2	Verify that the high beam indicator is inoperative. Does the high beam indicator operate normally?	Go to TESTING FOR INTERMITTENT CONDITIONS AND POOR CONNECTIONS in Wiring Systems	Go to Step 3
3	Turn the ignition switch to the RUN position. Turn the headlamp switch to the HEAD position. Place the multifunction headlamp dimmer switch to the high beams position. Do the high beam headlamps function properly?	Go to Step 4	Go to Symptoms - Lighting Systems
4	Using a scan tool, select IPC, Special Functions, and command the Lamp Test ON, then OFF. Does the high beam indicator lamp turn ON and OFF when commanded?	Go to TESTING FOR INTERMITTENT CONDITIONS AND POOR CONNECTIONS in Wiring Systems	Go to Step 5
5	Inspect for poor connections at the harness connector of the Instrument Panel Cluster (IPC). Refer to CIRCUIT TESTING and WIRING REPAIRS in Wiring Systems. Did you find and correct the condition?	Go to Step 7	Go to Step 6
6	IMPORTANT: Perform the set up procedure for the IPC. Replace the IPC. Refer to INSTRUMENT PANEL CLUSTER (IPC) REPLACEMENT in Instrument Panel, Gages, and Console.Did you complete the replacement?	Go to Step 7	-
7	Operate the system in order to verify the repair. Did you correct the condition?	System OK	Go to Step 3