Headlamp Switch On Indicator Inoperative
WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
Headlamp Switch On Indicator Inoperative
| Step | Action | Yes | No |
|---|---|---|---|
| Schematic Reference: Interior Lights Dimming Schematics | |||
| 1 | Did you perform the Lighting Systems Diagnostic System Check? | Go to Step 2 | Go to Diagnostic System Check - Lighting Systems |
| 2 | Verify that the headlamp switch on indicator is inoperative. Does the headlamp switch on indicator operate properly? |
Go to TESTING FOR INTERMITTENT CONDITIONS AND POOR CONNECTIONS in Wiring Systems | Go to Step 3 |
| 3 | Are the headlamps operating properly? | Go to Step 4 | Go to Symptoms - Lighting Systems |
| 4 |
|
Go to Step 6 | Go to Step 5 |
| 5 | Test the headlamp on indicator control circuit for an open, high resistance or short to voltage. Refer to CIRCUIT TESTING
and WIRING REPAIRS
in Wiring Systems. Did you find and correct a condition? |
Go to Step 11 | Go to Step 8 |
| 6 | Test the headlamp indicator LED dimming circuit for an open or high resistance. Refer to CIRCUIT TESTING
and WIRING REPAIRS
in Wiring Systems. Did you find and correct a condition? |
Go to Step 11 | Go to Step 7 |
| 7 | Inspect for poor connections at the harness connector of the headlamp switch. Refer to CIRCUIT TESTING
and WIRING REPAIRS
in Wiring Systems. Did you find and correct the condition? |
Go to Step 11 | Go to Step 9 |
| 8 | Inspect for poor connections at the harness connector of the Body Control Module (BCM). Refer to CIRCUIT TESTING
and WIRING REPAIRS
in Wiring Systems. Did you find and correct the condition? |
Go to Step 11 | Go to Step 10 |
| 9 | Replace the headlamp switch. Refer to Headlamp Switch Replacement . Did you complete the repair? |
Go to Step 11 | - |
| 10 |
IMPORTANT:
Perform the setup procedure for the BCM. Replace the body control module (BCM). Refer to BODY CONTROL MODULE REPLACEMENT
in Body Control System.Did you complete the replacement? |
Go to Step 11 | - |
| 11 | Operate the system in order to verify the repair. Did you correct the condition? |
System OK | Go to Step 3 |