LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1656 (Cruise Control System) >> Diagnostic Information and Procedures >> DTC P0567 >> Test Description

Test Description

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.

The numbers below refer to the step numbers on the diagnostic table.

  1. 2:  This step determines if condition is present.
  2. 3:  This step determines if the switch is at fault.
DTC P0567

Step Action Yes No
Schematic Reference: Cruise Control Schematics 
1 Did you perform A Diagnostic System Check - Cruise Control? Go to Step 2  Go to Diagnostic System Check - Cruise Control 
2 
IMPORTANT: If DTC P1518 is also set, diagnose P1518 first.
  1. Install a scan tool.
  2. Turn ON the ignition, with the engine OFF.
  3. Turn OFF the cruise control switch.
  4. Observe the resume/accel parameter in the PCM data list.
Does the scan tool parameter indicate that the Cruise Resume/Accel switch is ON?		 Go to Step 3  Go to Diagnostic Aids
3 
  1. Turn OFF the ignition.
  2. Disconnect the cruise control switch harness connector.
  3. Turn ON the ignition, with the engine OFF.
  4. Monitor the cruise control Resume/Accelerate switch parameter in the PCM data list.
Does the scan tool indicate that the cruise control Resume/Accelerate switch is ON?		 Go toStep 4  Go toStep 5 
4 Test the cruise control Resume/Accelerate switch signal circuit for a short to voltage. Refer to CIRCUIT TESTING and WIRING REPAIRS in Wiring Systems.
Did you find and correct the condition?		 Go to Step 9  Go toStep 6 
5 Inspect for poor connections at the harness connector of the cruise control switch. Refer to TESTING FOR INTERMITTENT CONDITIONS AND POOR CONNECTIONS and CONNECTOR REPAIRS in Wiring Systems.
Did you find and correct the condition?		 Go to Step 9  Go to Step 7 
6 Inspect for poor connections at the harness connector of the PCM. Refer to TESTING FOR INTERMITTENT CONDITIONS AND POOR CONNECTIONS and CONNECTOR REPAIRS in Wiring Systems.
Did you find and correct the condition?		 Go to Step 9  Go to Step 8 
7 Replace the cruise control switch. Refer to MULTIFUNCTION, TURN SIGNAL & HAZARD SWITCH in Steering Wheel and Column.
Did you complete the repair?		 Go to Step 9  -
8
IMPORTANT: The PCM must be reprogrammed after replacement. Refer to POWERTRAIN CONTROL MODULE .
Replace the PCM. Refer to POWERTRAIN CONTROL MODULE .Did you complete the repair?		 Go to Step 9  -
9
  1. Use the scan tool in order to clear the DTCs.
  2. Operate the vehicle within the Conditions for Running the DTC as specified in the supporting text.
Does the DTC reset?		 Go to Step 2  System OK
scientia non olet · About LEMON Manuals