Cruise Control Indicator Always On
WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
Cruise Control Indicator Always On
| Step | Action | Yes | No |
|---|---|---|---|
| Schematic Reference: Cruise Control Schematics | |||
| 1 | Did you perform A Diagnostic System Check- Cruise Control? | Go to Step 2 | Go to Diagnostic System Check - Cruise Control |
| 2 |
|
Go to Step 3 | Go to Step 4 |
| 3 | With a scan tool, observe the Cruise parameter in the PCM data list. Does the scan tool indicate that the cruise control is engaged? |
Go to DIAGNOSTIC SYSTEM CHECK -- ENGINE CONTROLS | Go to Step 4 |
| 4 | Inspect for poor connections at the harness connector of the instrument cluster. Refer to TESTING FOR INTERMITTENT CONDITIONS AND POOR CONNECTIONS
and CONNECTOR REPAIRS
in Wiring Systems. Did you find and correct the condition? |
Go to Step 6 | Go to Step 5 |
| 5 |
IMPORTANT:
The IPC must be reprogrammed. Refer to INSTRUMENT PANEL CLUSTER (IPC) PROGRAMMING/SYNCHRONIZATION
in Instrument Panel, Gages, and Console. Replace the instrument panel cluster. Refer to INSTRUMENT PANEL CLUSTER (IPC)
in Instrument Panel, Gages and Consoles.Did you complete the replacement? |
Go to Step 6 | - |
| 6 | Operate the system in order to verify the repair. Did you correct the condition? |
System OK | Go to Step 2 |