LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1655 (Cellular Communication System) >> Diagnostic Information and Procedures >> OnStar Symptom Diagnosis >> Diagnostic Aids

Diagnostic Aids

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Cadillac Escalade EXT. However, it is still accessible from the selected car via links, so may be relevant.
OnStar Symptom Diagnosis

Step Action Yes No
1 Did you perform the Diagnostic System Check? Go to Step 2  Go to Diagnostic System Check - Cellular Communication 
2
  1. Turn ON the ignition, with the engine OFF.
  2. Observe the OnStar® status LED
Does the LED turn Green?
Go to Step 3  Go to OnStar Button LED Inoperative 
3
  1. Turn the radio ON
  2. Set volume to a comfortable level
  3. Press the OnStar® Call Center button
  4. Wait approximately 10 seconds then end the call by pressing the white "dot" button.
Does both the OnStar® LED blink after the OnStar® keypress is made and the call ended after pressing the white "dot" button?
Go to Step 4  Go to OnStar One or More Buttons Inoperative 
4 After the OnStar® keypress does both the radio mute and is the "Connecting to OnStar" message heard playing through the audio system? Go to Step 5  Go to No (or Noisy) OnStar Audio 
5
IMPORTANT: It is important to have the vehicle in an open outside area where a cellular call can be successfully placed and GPS data can be received from satellites.
  1. Press the OnStar® Call Center button
  2. Wait for the system to either connect or end the call
Is a connection made with OnStar?
Go to Step 6  Go to Step 9 
6
IMPORTANT: : It is necessary to inform the OnStar® Call Center advisor that this call is for vehicle diagnostic purposes.
Ask the OnStar® Call Center advisor if your voice can clearly be heard.Does the advisor clearly hear your voice?
Go to Step 7  Go to Microphone Inoperative - Caller Cannot Be Heard 
7 Ask the OnStar® Call Center Advisor if they have received any data from the customer vehicle.
Did data transfer of the OnStar® call occur?
Go to Step 8  Go to Step 11 
8 Ask the OnStar® Call Center advisor if the vehicle has ever been configured.
Has the vehicle been configured?
Go to Step 10  Go to Step 16 
9 Is the audio prompt "Unable to Contact OnStar" heard? Go to Unable to Contact OnStar Call Center  Go to Step 12 
10 Ask the OnStar® Call Center advisor to verify the Vehicle Identification Number (VIN) which they have on record and ensure it matches the actual VIN.
Does the Vehicle Identification Number at the OnStar® Call Center match the Vehicle Identification Number of the vehicle?
Go to Step 13  Go to Step 15 
11 Ask the OnStar® Call Center advisor if this call was a "fail to voice".
Was this call a fail to voice?
Use the scan tool to access the STID and ESN and contact the General Motors Technical Assistance Center -
12 Is the audio prompt "OnStar® Request Ended" heard? Go to Diagnostic Aids -
13 Ask the OnStar® Call Center advisor to verify your position.
Is the location provided by the OnStar® Call Center advisor within a reasonable distance from the actual location of the vehicle?
Go to Step 14  Go to Global Positioning System (GPS) Data Not Current or Inaccurate 
14 Ask the OnStar® Call Center Advisor if the GPS position is marked as "Current".
Is the GPS position current?
Go to Step 17  Go to Global Positioning System (GPS) Data Not Current or Inaccurate 
15 Ask the OnStar® Call Center advisor to update the customer account with the correct information.
Has the customer account been updated?
Go to Step 16  -
16 Ask the OnStar® Call Center advisor to perform a Reconfiguration on the vehicle.
Was the Reconfiguration successful?
Go to Step 18  Ask the OnStar® Call Center advisor why the reconfiguration was not successful, use the scan tool to access the STID and ESN and contact the General Motors Technical Assistance Center
17 Is the customer concern with the inability of the OnStar® Call Center to perform remote functions? Go to OnStar Call Center Remote Function Requests Inoperative  Go to Diagnostic Aids
18 Operate the system in order to verify the customer concern has been corrected.
Has the customer concern been corrected?
System OK Go to Step 2