LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1653 (Battery, Charging System And Starting System) >> Repair Instructions >> Starter Motor Replacement (4.2L Engine) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the starter motor.
    2. NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
    Fig 1: View Of Starter Mount & Bolt
    GM759316Courtesy of GENERAL MOTORS CORP.
  2. Install the starter motor mount bolt (2) and nut (1).

    Tighten:  Tighten the starter mount bolt and nut to 50 N.m (37 lb ft).

  3. Connect the positive battery cable to the starter solenoid and secure the cable with a nut (1).

    Tighten:  Tighten the positive cable nut to 9 N.m (80 lb in).

    Fig 2: View Of Starter & Related Components
    GM754358Courtesy of GENERAL MOTORS CORP.
  4. Install the starter solenoid S-terminal lead (2) to the solenoid and secure the lead with a nut (1).

    Tighten:  Tighten the S-terminal nut to 2.3 N.m (20 lb in).

    Fig 3: View Of Starter Solenoid S-Terminal Lead & Nut
    GM1380362Courtesy of GENERAL MOTORS CORP.
  5. Install the vacuum brake booster hose. Refer to POWER BRAKE BOOSTER CHECK VALVE AND/OR HOSE in Hydraulic Brakes.
  6. Connect the battery negative cable. Refer to Battery Negative Cable Disconnect/Connect Procedure .
scientia non olet · About LEMON Manuals