LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1653 (Battery, Charging System And Starting System) >> Repair Instructions >> Battery Negative Cable Disconnect/Connect Procedure >> Connecting Procedure

Connecting Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Verify that all electrical components are off such as interior lights, all doors are closed, the underhood lamp, etc.
  2. Clean any corrosion from the negative battery cable using a wire brush.
    Fig 1: Identifying Battery Cable Components
    GM899613Courtesy of GENERAL MOTORS CORP.
  3. Position the negative battery cable (5) to the battery.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  4. Tighten negative battery cable bolt.

    Tighten:  Tighten the bolt to 15 N.m (11 lb ft).