Retained Accessory Power (RAP) Inoperative (No Relay Class 2)

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.

Step	Action	Yes	No
Schematic Reference: Retained Accessory Power (RAP) Schematics
1	Did you perform the retained accessory power (RAP) diagnostic system check?	Go to Step 2	Go to Diagnostic System Check - Retained Accessory Power
2	Verify the doors are closed and perform the following: Turn ON the ignition with engine OFF for 5 seconds. Turn OFF the ignition. Do the RAP functions operate normally?	Go to TESTING FOR INTERMITTENT CONDITIONS AND POOR CONNECTIONS and CONNECTOR REPAIRS in Wiring Systems	Go to Step 3
3	Connect a scan tool. With the scan tool, observe all door jamb switches. Open and close each door. Does the scan tool display change from active to inactive?	Go to Step 4	Go to DIAGNOSTIC SYSTEM CHECK - LIGHTING SYSTEMS in Lighting Systems
4	Inspect for poor connections or terminal damage at the body control module (BCM). Refer to TESTING FOR INTERMITTENT CONDITIONS AND POOR CONNECTIONS and CONNECTOR REPAIRS and in Wiring Systems. Did you find and correct the condition?	Go to Step 6	Go to Step 5
5	IMPORTANT: Setup and reprogram the module. Replace the BCM. Refer to BODY CONTROL MODULE REPLACEMENT in Body Control System.Did you complete the replacement?	Go to Step 6	-
6	Enable RAP power mode to verify the repair. Did you correct the condition?	System OK	Go to Step 1