Installation Procedure

WARNING: This page is about a different car, the 2003 GMC Sierra, 2003 GMC Cab & Chassis Sierra, 2003 Chevrolet Silverado, and 2003 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Clean the top edge of the windshield surface with a 50/50 mixture of isopropyl alcohol and water by volume on a dampened lint-free cloth.
The new reveal molding should be fitted to the windshield prior to installation.
CAUTION: Refer to WINDOW RETENTION CAUTION .
Verify all primers and urethane adhesive are within expiration dates.
IMPORTANT: Use care when applying the prep (clear #1) to the windshield. This primer dries almost instantly, and may stain the viewing area of the windshield if not applied evenly.
Use a new dauber in order to apply glass prep (clear #1) to the channel area approximately 13 mm (1/2 in) to the upper edge of the windshield.

Fig 1: Applying Primer

Courtesy of GENERAL MOTORS CORP.

Wipe the glass primed area immediately with a clean lint-free cloth.
Shake the glass primer (black #2) for at least one minute.
Using a new dauber in order to apply glass primer (black #2) to the top edge of the windshield.
Apply a small bead of urethane adhesive (2) between the windshield (1) and the pinchweld.

Fig 2: Installing Adhesive
Courtesy of GENERAL MOTORS CORP.
Install the upper reveal molding.
1. Start from the center and hand-press the reveal molding into place over the edge of the windshield.
2. Install both right and left sides of the reveal molding. Refer to Windshield Side Reveal Molding Replacement .
3. Run warm water over the reveal molding in order to speed the setup time of the urethane adhesive.
  Tape should be applied in order to retain the reveal molding to the windshield, this will maintain a flush fit with the body.
  
  The tape is to be removed after 6 hours.
  
  Fig 3: Installing Windshield Upper Reveal Molding
  Courtesy of GENERAL MOTORS CORP.