LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1628 (Wiring Systems (General Information)) >> Diagnostic Information and Procedures >> Repairing Connector Terminals >> Tools Required

Tools Required

WARNING: This page is about a different car, the 2003 GMC Sierra, 2003 GMC Cab & Chassis Sierra, 2003 Chevrolet Silverado, and 2003 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

J 38125-B  Terminal Repair Kit

Use the following repair procedures in order to repair the following:

Some terminals do not require all of the steps shown. Skip the steps that do not apply for your immediate terminal repair. The J 38125-B  contains further information.

  1. Cut off the terminal between the core and the insulation crimp. Minimize any wire loss.

    For Weather Pack® terminals, remove the seal.

  2. Apply the correct seal per gage size of the wire.

    For Weather Pack® terminals, slide the seal back along the wire in order to enable insulation removal.

  3. Remove the insulation.
  4. For Weather Pack® terminals only, align the seal with the end of the cable insulation.
  5. Position the strip in the terminal.

    For Weather Pack® terminals, position the strip and seal in the terminal.

  6. Hand crimp the core wings.
  7. Hand crimp the insulation wings.

    For Weather Pack® terminals, hand crimp the insulation wings around the seal and the cable.

  8. Solder all of the hand crimp terminals excepting Micro-Pack 100 World terminals. Soldering Micro-Pack 100 World terminals may damage the terminal.
scientia non olet · About LEMON Manuals