LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1626 (Automatic Transmission - 4L80-E - Service & Replacement) >> Repair Instructions >> Park/Neutral Position Switch Adjustment

Park/Neutral Position Switch Adjustment

WARNING: This page is about a different car, the 2003 GMC Sierra, 2003 GMC Cab & Chassis Sierra, 2003 Chevrolet Silverado, and 2003 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
  • The following procedure is for vehicles that have not had the park/neutral position (PNP) switch removed or replaced. If the switch has been removed or replaced, refer to Park/Neutral Position Switch Replacement for the proper adjustment procedure.
  • Apply the park brake.
  • The engine must start in the park (P) or neutral (N) positions only.
  • Check the PNP switch for proper operation. If adjustment is required, proceed as follows:
  1. Place the shift lever in the neutral (N) position.
  2. With an assistant in the drivers seat, raise and suitably support the vehicle. Refer to LIFTING AND JACKING THE VEHICLE .
  3. Loosen the PNP switch bolts.
  4. With the vehicle in neutral (N), rotate the PNP switch while the assistant attempts to start the engine.
  5. Following a successful start, turn the engine off.
    NOTE: Refer to FASTENER NOTICE .
  6. Tighten the PNP switch bolts.

    Tighten 

    Tighten the bolts to 25 N.m (18 lb ft).

  7. Lower the vehicle.
  8. Check the PNP switch for proper operation. The engine must start in the park (P) or neutral (N) positions only.
  9. Replace the PNP switch if proper operation can not be achieved. Refer to Park/Neutral Position Switch Replacement .
scientia non olet · About LEMON Manuals