Conditions for Running the DTC
WARNING: This page is about a different car, the 2003 GMC Sierra, 2003 GMC Cab & Chassis Sierra, 2003 Chevrolet Silverado, and 2003 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- No MAP sensor DTCs P0106, P0107, or P0108.
- No transmission component slipping DTC P0894.
- No TP sensor DTCs P0121, P0122, or P0123.
- No ISS sensor DTCs P0716 or P0717.
- No VSS DTCs P0502 or P0503.
- No MAF DTC P0101, P0102, or P0103.
- No TFP manual valve position switch DTC P1810.
- No shift solenoid electrical DTC P0753 or P0758.
- Not in 4WD Low.
- No TCC PWM solenoid valve DTC P1860.
- No TCC Stuck On DTC P0742.
- The system voltage is 10-18 volts.
- Transmission ISS is greater than 7 RPM.
- Transmission OSS is greater than 7 RPM.
- The engine vacuum is 0-105 kPa.
- The TP sensor is greater than 10 percent.
- The engine torque must be 108-576 N.m (80-425 lb ft).
- No TFP manual valve position switch change within 6 seconds.
- The TFP manual valve position switch indicates D4.
- The transmission fluid temperature (TFT) is greater than 20°C (68°F).