Conditions for Running the DTC
WARNING: This page is about a different car, the 2003 GMC Sierra, 2003 GMC Cab & Chassis Sierra, 2003 Chevrolet Silverado, and 2003 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- No MAF sensor DTCs P0101, P0102 or P0103.
- No MAP sensor DTCs P0106, P0107 or P0108.
- No TP sensor DTCs P0121, P0122 or P0123.
- No TFP manual valve position switch DTC P1810.
- No ISS DTCs P0716 or P0717.
- No VSS DTC P0503.
- The engine torque must be 108-576 N.m (80-425 lb ft).
- No change in 4WD low for at least 2 seconds.
- The input speed is greater than 1,400 RPM.
- The gear range is not PARK or NEUTRAL.
- The system voltage is 8-18 volts.
- Throttle angle is greater than 10 percent.
- The engine vacuum is 0-105 kPa (0-15 psi).
- The engine is running for greater than 7 seconds.