LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1625 (Automatic Transmission - 4L60-E - Service, Removal & Installation) >> Repair Instructions >> Transmission Oil Cooler Line Quick Connect Fitting >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 GMC Sierra and 2003 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: Perform the following procedure when removing the retaining rings and cooler lines from the quick connect fittings located on the radiator and/or the transmission.
  1. Pull the plastic cap back from the quick connect fitting and down along the cooler line about 5 cm (2 in).
  2. Using a bent-tip screwdriver, pull on one of the open ends of the retaining ring in order to rotate the retaining ring around the quick connect fitting until the retaining ring is out of position and can be completely removed.
  3. Remove the retaining ring from the quick connect fitting.
  4. Discard the retaining ring.
    Fig 1: Removing Retaining Ring From Quick Connect Fitting
    G01953550Courtesy of GENERAL MOTORS CORP.
  5. Pull the cooler line straight out from the quick connect fitting.
    Fig 2: Pulling Cooler Line From Quick Connect Fitting
    G01953551Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals