LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1625 (Automatic Transmission - 4L60-E - Service, Removal & Installation) >> Repair Instructions >> Park/Neutral Position Switch Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 GMC Sierra and 2003 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Apply the park brake.
  2. Shift the transmission into neutral.
  3. If equipped with 4-wheel drive (4WD), remove the front propeller shaft. Refer to PROPELLER SHAFT REPLACEMENT - FRONT .
  4. Raise and suitably support the vehicle. Refer to LIFTING AND JACKING THE VEHICLE .
  5. Disconnect the park/neutral position (PNP) switch electrical connectors (2).
    Fig 1: Disconnecting Park/Neutral Position Switch Electrical Connectors
    G01953532Courtesy of GENERAL MOTORS CORP.
  6. Remove the manual shaft lever nut.
  7. Remove the transmission control lever from the manual shaft.
  8. Remove the PNP switch bolts.
  9. Remove the PNP switch from the manual shaft. If the PNP switch did not slide off the manual shaft, file the outer edge of the manual shaft in order to remove any burrs.
    Fig 2: Removing Manual Shaft Lever Nut
    G01953533Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals