LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1625 (Automatic Transmission - 4L60-E - Service, Removal & Installation) >> Diagnostic Information and Procedures >> Automatic Transmission Oil Cooler Flushing and Flow Test >> Forward Flush

Forward Flush

WARNING: This page is about a different car, the 2003 GMC Sierra and 2003 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Disconnecting Hoses
G01953457Courtesy of GENERAL MOTORS CORP.
  1. Disconnect both hoses (1 and 2) from the oil cooler pipes and connect them to the opposite oil cooler pipe. This will allow the oil cooler and pipes to be flushed in the normal flow direction.
  2. Repeat Step 6 and 7 of the Back Flush.
    Fig 2: Trigger, Flushing System Feed Air Valve & J 35944-A Water Supply Valve
    G01953458Courtesy of GENERAL MOTORS CORP.
  3. Release the trigger (1) of the J 35944-A  and allow water only to rinse the oil cooler and pipes for 1 minute.
  4. Turn the J 35944-A  water supply valve (3) to the OFF position and turn OFF the water supply at the faucet.
  5. Attach the shop air supply to the flushing system feed air valve (2) on the J 35944-A  and blow out the water from the oil cooler and pipes.

    Continue, until no water comes out of the discharge hose.

scientia non olet · About LEMON Manuals