LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1625 (Automatic Transmission - 4L60-E - Service, Removal & Installation) >> Diagnostic Information and Procedures >> Automatic Transmission Oil Cooler Flushing and Flow Test >> Clean-up

Automatic Transmission Oil Cooler Flushing and Flow Test: Clean-up

WARNING: This page is about a different car, the 2003 GMC Sierra and 2003 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the water supply hose from the J 35944-A  and bleed any remaining air pressure from the flusher tank.
  2. Remove the fill cap from the J 35944-A  and return any unused flushing solution to its container. Rinse the J 35944-A  with water. Do not store the J 35944-A  with flushing solution in it.
  3. After every third use, clean the J 35944-A  as described in the instructions included with the tool.
  4. Dispose of any waste water/solution and transmission fluid in accordance with local regulations.