LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1624 (Manual Transmission - ZF S6-650) >> Repair Instructions >> Shift Lever Assembly Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 GMC Sierra, 2003 GMC Cab & Chassis Sierra, 2003 Chevrolet Silverado, and 2003 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install a NEW shift lever insulator, if required.
  2. Apply gasket maker GM P/N 12378517 or equivalent to the surface of the control lever assembly.
  3. Push the shift lever assembly back through the insulator, position and turn the shift lever assembly back into place.
  4. With a flat tool pull back the insulator between the body and transmission to install the shift lever assembly bolts.
    NOTE: Refer to FASTENER NOTICE .
  5. Install the shift lever assembly bolts.

    Tighten 

    Tighten the bolts to 23 N.m (17 lb ft).

  6. Install the control lever and boot. Refer to Control Lever And/Or Boot Replacement   . 
    Fig 1: Installing Shift Lever Insulator
    G01953173Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals