LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1619 (Engine Mechanical - 4.8L, 5.3L & 6.0L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Engine Mount Replacement - Right >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 GMC Sierra, 2003 GMC Cab & Chassis Sierra, 2003 Chevrolet Silverado, and 2003 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise the vehicle. Refer to JACKING AND LIFTING .
  2. Remove the tire and wheel. Refer to TIRES AND WHEELS .
  3. Remove the wheelhouse panel. Refer to WHEELHOUSE PANEL REPLACEMENT .
  4. Remove the exhaust manifold. Refer to EXHAUST MANIFOLD REPLACEMENT - RIGHT (4.8L, 5.3L, AND 6.0L ENGINES) .
  5. Remove the engine protection shield. Refer to ENGINE PROTECTION SHIELD REPLACEMENT .
  6. Remove the engine mount heat shield, if equipped.
    Fig 1: View Of Engine Mount Heat Shield
    GM1235951Courtesy of GENERAL MOTORS CORP.
    7. IMPORTANT: DO NOT raise and/or support the engine by the crankshaft balancer, or oil pan.
  7. Raise and support the engine using an adjustable (screw type) jack stand.
  8. Remove the engine mount-to-engine mount bracket bolts.
    Fig 2: View Of Engine Mount-To-Engine Mount Bracket
    GM307275Courtesy of GENERAL MOTORS CORP.
  9. Remove the engine mount bolts.
    Fig 3: View Of Right Engine Mount
    GM307279Courtesy of GENERAL MOTORS CORP.
  10. Remove the right engine mount.
scientia non olet · About LEMON Manuals