LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1619 (Engine Mechanical - 4.8L, 5.3L & 6.0L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Engine Mount Replacement - Right >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 GMC Sierra, 2003 GMC Cab & Chassis Sierra, 2003 Chevrolet Silverado, and 2003 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the right engine mount to the engine.
    NOTE: Refer to FASTENER NOTICE .
  2. Install the engine mount bolts to the engine.

    Tighten 

    Tighten the engine mount bolts to 50 N.m (37 lb ft).

    Fig 1: View Of Right Engine Mount
    GM307279Courtesy of GENERAL MOTORS CORP.
  3. Install the engine mount-to-engine mount bracket bolts.
    Fig 2: View Of Engine Mount-To-Engine Mount Bracket
    GM307275Courtesy of GENERAL MOTORS CORP.
  4. Lower the engine.
  5. Remove the adjustable jack stands.
  6. Install the engine mount heat shield, if equipped.

    Tighten:  Tighten the engine mount-to-engine mount bracket bolts to 65 N.m (48 lb ft).

  7. Install the exhaust manifold. Refer to EXHAUST MANIFOLD REPLACEMENT - RIGHT (4.8L, 5.3L, AND 6.0L ENGINES) .
  8. Install the wheelhouse panel. Refer to WHEELHOUSE PANEL REPLACEMENT
  9. Install the engine protection shield. Refer to ENGINE PROTECTION SHIELD REPLACEMENT .
  10. Install the tire and wheel. Refer to TIRES AND WHEELS .
  11. Lower the vehicle.
scientia non olet · About LEMON Manuals