LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1619 (Engine Mechanical - 4.8L, 5.3L & 6.0L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Drive Belt Idler Pulley Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 GMC Sierra, 2003 GMC Cab & Chassis Sierra, 2003 Chevrolet Silverado, and 2003 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Loosen the drive belt idler pulley bolt.
  2. Remove the accessory drive belt. Refer to DRIVE BELT REPLACEMENT - ACCESSORY .
  3. Remove the drive belt idler pulley and bolt.
    Fig 1: Removing Drive Belt Idler Pulley & Bolt
    G02106576Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals