LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1619 (Engine Mechanical - 4.8L, 5.3L & 6.0L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Crankshaft Rear Oil Seal Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 GMC Sierra, 2003 GMC Cab & Chassis Sierra, 2003 Chevrolet Silverado, and 2003 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
  • The flywheel spacer (if applicable) must be removed prior to oil seal installation.
  • Do not lubricate the oil seal inside diameter (ID) or the crankshaft surface.
  • Do not reuse the crankshaft rear oil seal.
  1. Lubricate the outside diameter (OD) of the oil seal (1) with clean engine oil.

    DO NOT allow oil or other lubricants to contact the seal surface.

  2. Lubricate the rear cover oil seal bore with clean engine oil.

    DO NOT allow oil or other lubricants to contact the crankshaft surface.

    Fig 1: Crankshaft Rear Oil Seal
    G02106723Courtesy of GENERAL MOTORS CORP.
  3. Install the J 41479  tapered cone (2) and bolts onto the rear of the crankshaft.
  4. Tighten the bolts until snug. Do not overtighten.
  5. Install the rear oil seal onto the tapered cone (2) and push the seal to the rear cover bore.
  6. Thread the J 41479  threaded rod into the tapered cone until the tool (1) contacts the oil seal.
  7. Align the oil seal into the tool (1).
  8. Rotate the handle of the tool (1) clockwise until the seal enters the rear cover and bottoms into the cover bore.
  9. Remove the J 41479  .
  10. Install the engine flywheel. Refer to Engine Flywheel Replacement .
    Fig 2: J 41479 & Tapered Cone
    G02106724Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals