LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1618 (Engine Mechanical - 4.3L) >> Diagnostic Information and Procedures >> Drive Belt Tensioner Diagnosis >> Inspection Procedure

Inspection Procedure

WARNING: This page is about a different car, the 2003 GMC Sierra and 2003 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Drive Belt Movement Direction
G02105709Courtesy of GENERAL MOTORS CORP.
NOTE: Allowing the drive belt tensioner to snap into the free position may result in damage to the tensioner.
IMPORTANT: When the engine is operating the drive belt tensioner arm will move. Do not replace the drive belt tensioner because of movement in the drive belt tensioner arm.
  1. Remove the drive belt. Refer to Drive Belt Replacement .
  2. Move the drive belt tensioner through it's full travel.
    • The movement should feel smooth
    • There should be no binding
    • The tensioner should return freely
  3. If any binding is observed, replace the drive belt tensioner. Refer to Drive Belt Tensioner Replacement  .  .
  4. Install the drive belt. Refer to Drive Belt Replacement .
scientia non olet · About LEMON Manuals