Tools Required

J 35667-A  Cylinder Head Leakdown Tester With the use of air pressure, a cylinder leakage test will aid in the diagnosis. Use the cylinder leakage test in conjunction with the engine compression test in order to isolate the cause of leaking cylinders.

1. Disconnect the battery ground negative cable.
2. Remove the spark plugs. Refer to SPARK PLUG .
3. Rotate the crankshaft to place the piston in the cylinder being tested at top dead center (TDC) of the compression stroke, with both valves closed.
4. Install the J 35667-A  .
   IMPORTANT: It may be necessary to hold the crankshaft balancer bolt to prevent piston movement.
5. Apply shop air pressure to the J 35667-A  and adjust according to the manufacturer instructions.
   IMPORTANT: Perform the leakage test on all cylinders and record the values before doing any repairs.
6. Record the cylinder leakage value. Cylinder leakage that exceeds 25 percent is considered excessive and may require component service. In excessive leakage situations, inspect for the following conditions:
   1. 6.1. Air leakage from the intake or exhaust system may indicate a worn or burnt valve or a broken valve spring.
      1. 6.1.1. Remove the valve rocker arm cover of the suspect cylinder head. Refer to Valve Rocker Arm Cover Replacement - Left  or Valve Rocker Arm Cover Replacement - Right .
      2. 6.1.2. Ensure that both valves are closed.
      3. 6.1.3. Inspect the cylinder head for a broken valve spring.
      4. 6.1.4. Remove and inspect the suspect cylinder head. Refer to Cylinder Head Replacement - Left   or  Cylinder Head Replacement - Right   .
   2. 6.2. Air leakage from the crankcase, oil level indicator, or oil fill tube may indicate worn piston rings, a damaged piston, a worn or scored cylinder bore, a damaged engine block or a damaged cylinder head.
      1. 6.2.1. Remove the piston from the suspect cylinder. Refer to Piston, Connecting Rod, and Bearing Removal  or Piston, Connecting Rod, and Bearing Installation .
      2. 6.2.2. Inspect the piston and connecting rod assembly. Refer to Piston, Connecting Rod, and Bearings Cleaning and Inspection  .  .
      3. 6.2.3. Inspect the engine block. Refer to Engine Block Cleaning and Inspection .
      4. 6.2.4. Inspect the cylinder head. Refer to Cylinder Head Cleaning and Inspection .
   3. 6.3. Air bubbles in the cooling system may indicate a damaged cylinder head or a damaged cylinder head gasket.
      1. 6.3.1. Remove both cylinder heads. Refer to Cylinder Head Replacement - Left   or  Cylinder Head Replacement - Right   .
      2. 6.3.2. Inspect both cylinder heads. Refer to Cylinder Head Cleaning and Inspection .
      3. 6.3.3. Inspect the engine block. Refer to Engine Block Cleaning and Inspection .
7. Remove the J 35667-A  .
8. Install the spark plugs. Refer to SPARK PLUG .
   CAUTION: Refer to BATTERY DISCONNECT CAUTION .
9. Connect the battery ground negative cable.