LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1608 (Front Suspension System) >> Repair Instructions >> Lower Ball Joint Replacement (Torsion Bar Suspension) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 GMC Sierra, 2003 GMC Cab & Chassis Sierra, 2003 Chevrolet Silverado, and 2003 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to JACKING AND LIFTING .
  2. Remove the tire and wheel assembly. Refer to TIRE AND WHEEL REMOVAL AND INSTALLATION  .
  3. Remove the lower control arm. Refer to Lower Control Arm Replacement (RWD)  or Lower Control Arm Replacement (4WD) .
  4. Place the lower control arm in a bench vice.
  5. Using a chisel, remove the securing crimps from the ball joint body, if equipped.
  6. Using a press, remove the ball joint from the lower control arm.
scientia non olet · About LEMON Manuals