LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1608 (Front Suspension System) >> Repair Instructions >> Lower Ball Joint Replacement (Coil Spring Suspension) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 GMC Sierra, 2003 GMC Cab & Chassis Sierra, 2003 Chevrolet Silverado, and 2003 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the ball joint to the lower control arm.
  2. Install the replacement bolts to the lower control arm.
    NOTE: Refer to FASTENER NOTICE .
  3. Install the nuts to the bolts.

    Tighten 

    Tighten the nuts to 70 N.m (52 lb ft).

  4. Remove the lower control arm from the bench vice.
  5. Install the lower control arm. Refer to Lower Control Arm Replacement (RWD)  or Lower Control Arm Replacement (4WD) .
  6. Install the tire and wheel tire assembly. Refer to TIRE AND WHEEL REMOVAL AND INSTALLATION  .
  7. Remove the safety stands.
  8. Lower the vehicle.
  9. Verify the wheel alignment. Refer to MEASURING WHEEL ALIGNMENT (WITH REAR WHEEL STEERING)  or MEASURING WHEEL ALIGNMENT (WITHOUT REAR WHEEL STEERING)  .
scientia non olet · About LEMON Manuals