LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1606 (Steering Wheel And Steering Column) >> Repair Instructions >> Steering Column Tilt Head Housing Replacement (Tilt) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 GMC Sierra, 2003 GMC Cab & Chassis Sierra, 2003 Chevrolet Silverado, and 2003 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the tilt head onto the steering shaft.
  2. Install the tilt head housing and steering shaft as an assembly. Refer to Lower Bearing and Steering Column Jacket Replacement (Floor Shift Lean Shaft)  or Lower Bearing and Steering Column Jacket Replacement (Floor Shift Lean Shaft)  or Lower Bearing and Steering Column Jacket Replacement (Floor Shift Standard) .
    IMPORTANT: The switch mounting bracket must be pressed firmly against the steering column tilt head.
  3. Slide the turn signal switch housing onto the steering column shaft assembly.
  4. Install the turn signal and multifunction switch assembly only. Refer to Multifunction, Turn Signal Switch Replacement .
    Fig 1: Installing Tilt Head Onto Steering Shaft
    G01479796Courtesy of GENERAL MOTORS CORP.
  5. Install the turn signal cancel cam assembly. Refer to Turn Signal Cancel Cam and Upper Bearing Thrust Washer .
  6. Enable the SIR system. Refer to ZONE 3 .
scientia non olet · About LEMON Manuals