LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1605 (Power Steering System) >> Repair Instructions >> Steering Gear Cylinder Pipe Assemblies/O-Ring Seals Replacement - Off Vehicle (Quiet Valve) >> Disassembly Procedure

Disassembly Procedure

WARNING: This page is about a different car, the 2003 GMC Sierra, 2003 GMC Cab & Chassis Sierra, 2003 Chevrolet Silverado, and 2003 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Loosen both cylinder line fittings on the cylinder end of the gear assembly.
  2. Loosen both fittings on the cylinder line assemblies (1) at the valve end of the gear assembly.
  3. Remove both cylinder line assemblies (1) from the rack and pinion gear assembly (2).
    4. Fig 1: Remove Both Cylinder Line Assemblies From Rack & Pinion Gear Assembly
    G01479591Courtesy of GENERAL MOTORS CORP.
  4. Remove the O-ring seals (1) from the valve end of line.
  5. Discard the O-ring seals (1).
Fig 2: Remove O-Ring Seals From Valve End Of Line
G01479592Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals